A few days ago, I went out with my colleagues to test the material, the customer is doing electronic products, using our TPE material to wrap the rubber, because they have determined the main material is ABS, just use our TPE material to wrap the rubber external area, plus the sky blue, already looks beautiful, so there are not a lot of requirements for our TPE material, is a little, can wrap well on OK. I specially came to a piece of our often used to wrap the rubber ABS material sent over to try, the first time the customer himself where to try, and then after a week back to my phone, the package is not tight, I thought, impossible ah! I thought, "That's impossible! It was OK before, never had any problem, what was the problem? So, I specially brought 3KG to run over to see the situation on the day the customer called, because I believe that this material is absolutely OK, so I did not even make a backup plan to go over.

　　The second point is that although the mold release agent is useful when he takes off the mold, he is in a hurry, so he just takes off the mold and tests it there to see if it can be wrapped tightly, and once he pulls it, it doesn't cool down, so he is sure it will detach and it will not be wrapped tightly. The third point, his temperature simply did not reach, test TPE, in general, the second area of the temperature will now be relatively high.

　　In accordance with these problems I have said, the customer deliberately ran over to take the latest ABS mold into the test material, and then adjust the temperature of the second zone, and again test material, the first mold really out to the side after a few minutes of cooling, you can successfully pack. The back of the back, I should not say more, since the customer has tried the material, it will certainly place an order, in fact, the package of rubber trial material is a process, has been successful material, it is impossible to have a bad package of the situation.