How to deal with the overflowing edge of the TPE wrapped handle
Time of issue:2023-06-19
In the TPE package often appear phi phenomenon, so what is the cause of the problem of phi? What are the solutions? The following let the plastic for everyone to understand.
What is the "phi front" it? This call from Taiwan, there will also be part of this call, the book called the "edge of the spill", commonly known as the edge of the burr, burr is often found in the plastic injection molding products or mold cavity fusion line or hole position and other parts, is the edge of the burr, burr, the main reason for two kinds: 1, mold reasons: mold clamping line:
1, mold reasons: mold clamping surface gap, mechanical parts with bad or parts deformation, inequality may lead to burrs.
2, injection molding pressure, speed is too fast.
Solutions:
1, check the mold, whether there are foreign objects attached to the mold parting surface, resulting in clamping is not tight; whether there is damage to the spare parts, whether the spare parts with bad, targeted maintenance.
2, reduce the corresponding injection molding process.
a) injection pressure is too large, need to reduce or earlier from injection pressure to pressure-holding
b) Reduce the screw forward time and lower the injection speed.
c) Properly reduce the injection volume and lower the temperature of the melt.
Regarding the overflowing of TPE handle, we analyzed the problem from the mold and molding, and gave the solution, hope it will be helpful to you.
TEL: +86-0752-6768128 FAX: +86-0752-6768088 MAIL: sales@tpe-sp.com WEB: en.tpe-sp.com
ADD: Huangxi Industrial Park, Shiwan Town, Boluo County, Huizhou City, Guangdong Province，China